The two practical papers at a glance
| Paper 3 Advanced Practical Skills | Paper 5 Planning, Analysis and Evaluation | |
|---|---|---|
| Time | 2 hours | 1 hour 15 minutes |
| Marks | 40 | 30 |
| Format | Laboratory-based practical work and structured questions | Written paper; no laboratory facilities needed |
| Questions | Two questions, each 1 hour and 20 marks | Two compulsory questions, each 15 marks |
| Share of AS Level | 23% | Not part of AS Level |
| Share of A Level | 11.5% | 11.5% |
The syllabus says the questions in both papers may be based on physics not included in the syllabus content, because candidates are assessed on their practical skills rather than their theory. Where needed, candidates are given the information they need.
Paper 3: what the two questions ask
- Question 1 is an experiment in which you collect data, plot a graph and draw conclusions.
- Question 2 is an experiment in which you collect data and draw conclusions, and it may or may not include a graph. The method you are given is inaccurate, so you must evaluate it and suggest improvements.
- The two questions are set in different areas of physics, and no prior knowledge of the theory is required.
The mark allocation shows where the marks sit. In Question 1 the syllabus gives minimum marks of 7 for manipulation, measurement and observation (collection and quality of data, table of results), 6 for presentation of data and observations (recording and graph), and 4 for analysis, conclusions and evaluation, with the remaining 3 marks allocated across those skills and varying from paper to paper. In Question 2 the minimums are 5, 2 and 10 for the same three skill groups, again with 3 marks that vary. Analysis in Question 2 includes drawing conclusions, estimating uncertainties, identifying limitations and suggesting improvements.
Paper 5: planning, analysis and evaluation
- Question 1 is a planning question. You design an experimental investigation of a given problem, and the question is not highly structured: you answer with a diagram and an extended piece of writing.
- Question 2 gives you an equation and some experimental data, and you find the value of a constant. It is structured, but you decide what you need to do to reach an answer, and you also estimate the uncertainty in your answer.
- No question needs theory or equipment beyond the syllabus, and some may be set in areas that are hard to investigate in school laboratories, such as radioactive materials.
| Question | Skills the 15 marks cover |
|---|---|
| Question 1 (planning) | Defining the problem; methods of data collection; method of analysis; additional detail including safety considerations |
| Question 2 (analysis, conclusions and evaluation) | Data analysis; table of results; graph; conclusion; treatment of uncertainties |
A planning example in the style of Paper 5
This is an original practice outline, not taken from a past paper. Task: plan an investigation of how the period T of a simple pendulum depends on its length L.
- Define the problem: the independent variable is L, the dependent variable is T, and the control variables are the mass of the bob, the starting angle and the same pendulum set-up.
- Collect data: measure L from the pivot to the centre of the bob with a ruler, time 20 oscillations with a stopwatch and divide by 20 to find T, and repeat for at least six lengths across a wide range.
- Analysis: T² = (4π²/g) × L, so plotting T² on the y-axis against L on the x-axis should give a straight line through the origin with gradient 4π²/g, from which g can be found.
- Safety and detail: clamp the support firmly, keep the swing away from people, use a small angle, and fix the pivot so the length does not change during swings.
Where students lose marks
- Planning without naming the independent, dependent and control variables, or without saying how each is measured.
- Collecting too few values over too narrow a range, so the graph has little to show.
- Writing a table without headings that include the quantity and its unit.
- Forgetting to carry uncertainties through to the final value, or giving a gradient without checking it uses the line, not two data points.
- In Paper 3 Question 2, describing what is wrong with the method but not suggesting a specific improvement.
- Spending the whole hour on Question 1 in Paper 3 and leaving too little time for Question 2.
How a tutor would approach this
A tutor goes through a practical question with you slowly: what is the aim, which variables matter, what would the table look like, what graph gives a straight line. In the free demo, bring a Paper 3 or Paper 5 question you found hard.
See the matching syllabus page →Frequently asked questions
How long are Paper 3 and Paper 5?
Paper 3 is 2 hours and 40 marks. Paper 5 is 1 hour 15 minutes and 30 marks.
Does Paper 5 need a laboratory?
No. The syllabus says Paper 5 is a written paper that does not require laboratory facilities.
What does Paper 3 Question 2 usually involve?
An experiment where you collect data and draw conclusions, using an inaccurate method that you must evaluate and improve. It may or may not include a graph.
How much of the A Level do the practical papers count for?
Paper 3 counts for 11.5% of the A Level and Paper 5 counts for 11.5%.
Can a tutor help me prepare for the practical papers?
Yes. A tutor can work through planning, tables, graphs and uncertainties with you online. The first 30-minute demo is free.
Official sources
- Cambridge International AS & A Level Physics 9702 syllabus for 2025, 2026 and 2027 (official PDF), practical assessment (checked 2026-11-17)
- Cambridge International: AS & A Level Physics 9702 (checked 2026-11-17)
Related pages
Try a free 30-minute demo
Work through a question with a tutor. No payment needed.
Request a free 30-minute demo